CD74HC4067 Breakout Board 16-Channel Analog/Digital Multiplexer Breakout Board Module Easy-to-Use Multiplexer Board for Arduino - RS1164

SKU RS1164

Connect one controller signal to any of sixteen channels with this CD74HC4067 breakout board. Four binary address lines choose the active channel, making it useful when a project

₹58.50

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

CD74HC4067 16-Channel Analog/Digital Multiplexer Board

Connect one controller signal to any of sixteen channels with this CD74HC4067 breakout board. The chip is a bidirectional analog switch: it can route one of sixteen sensor signals to a common input, or route a common signal to one selected output. Four binary address lines choose the active channel, making it useful when a project needs more signal connections than the controller provides directly.

Board connections

C0-C15: the sixteen switched channels.

SIG: common signal input/output.

S0-S3: channel-select address inputs, from binary 0000 for C0 to 1111 for C15.

EN: active-high disable input. A high level disconnects all channels; a low level allows the selected channel to connect.

VCC and GND: supply and common ground.

Electrical details

CD74HC4067 HC-family device with a 2-6V operating supply range.

Analog signals must stay within the device's supply rails.

Typical on resistance is 70 ohms at a 4.5V supply, so the switch is not a zero-resistance connection.

Break-before-make switching helps prevent two channels being connected during a selection change.

Application notes Use this board for reading banks of potentiometers, scanning suitable sensors or selecting low-current signal paths. It is not an ADC, a voltage amplifier or a high-current load driver. Only one channel is selected at a time. Allow signals to settle after changing the address, especially with high-impedance sensors or ADC inputs. Match control logic levels to the selected supply voltage and check the chip's input thresholds. The board does not provide automatic level conversion or protection against signals outside its rails. Headers may require soldering.

Package contents 1 x CD74HC4067 16-channel multiplexer breakout board

More in Sensor Modules

You might also need