About this product
Analogue piezoelectric vibration sensor module
RS4983 combines a wired piezoelectric ceramic disc with a small interface board for knock, tap and vibration experiments. Mechanical strain on the disc produces an electrical signal that can be observed with a suitable analogue input. It is useful for interactive surfaces, percussion-style demonstrations and learning how mechanical events become electrical signals.
Board and connections
Sensor element: piezoelectric ceramic disc with attached leads.
Interface: analogue signal output, not a ready-made digital alarm.
Controller header labels: S, + and -.
Disc terminal labels: INPUT and GND.
Package: 1 x piezo vibration sensor module with disc, SKU RS4983.
The product photos show a blue board with a two-position screw terminal and a three-pin header. Read the labels on the supplied PCB before wiring; do not infer pin order from a rotated image. This is not the spring-switch type of vibration sensor.
First connection
With power off, connect the disc leads to the matching INPUT and GND terminals. For a suitable 5V controller setup, connect + to regulated 5V, - to the shared ground and S to an analogue input such as A0 on an Arduino Uno. The existing listing specifies a maximum supply of 5V; do not exceed it.
Check the actual signal range and any piezo transients against the controller's ADC limits before connecting. A bare piezo element can generate voltage spikes. Do not bypass the module and feed an unprotected disc into a GPIO. A 5V arrangement is not automatically safe for ESP32 or another 3.3V input. Raspberry Pi single-board computers need an external ADC or a separate controller for analogue readings.
Mount and test
Support the disc on the test surface and secure the leads so the solder joints are not pulled. Do not crush the ceramic or sharply bend the disc. Start with gentle taps while plotting raw readings, then observe the quiet baseline. Mounting stiffness, surface material and tap position all affect the response.
Choose a software threshold above ordinary noise and add a short hold-off if one impact creates several peaks from ringing. Recheck after changing the mounting. The signal is not a calibrated measurement of force, acceleration or vibration frequency, and no guaranteed sensitivity or accuracy is claimed. This hobby module is not a safety-rated alarm. Controller and connecting wires are not included.