About this product
Description:
The AD9850 is a highly integrated device that uses advanced DDS technology coupled with an internal high speed, high performance, D/A converter and comparator, to form a complete digitally programmable frequency synthesizer and clock generator function.
DDS Function Generator Module all the external components which are needed are integrated on the board and the designer don’t need to care more about the detailed design of ADS9850. The designer only needs to add the power and control signals to driver this module
Specification:
Operating Voltage: 3.3 – 6 Volts
Oscillator Frequency: 125 MHz
Output Frequency: 0 – 40 MHz
Operational Temperature: -40 – 850C
Source/Sink Continuous Current: 0.005 Amperes
DAC Current: 0.03 Amperes
Power Dissipation(125 MHz, 5V): 380 mWatts
Power Dissipation(110 MHz, 3.3V): 110 mWatts
Features:
DAC with Spurious Free Dynamic Range to specify the generator’s performance
It contains a power-down function for a short boot time.
Data transmission can either be parallel or serial.
Power Dissipation depends on the power supply voltage.
Four Analog signal outputs i.e., Sine-Wave 1, Sine-Wave 2, Square-Wave 1, and Square-Wave 2
A comparator to generate less jittering in square wave output
Direct Digital Synthesizer is based on CMOS Technology for better functionality and performance.
A small high-performance module with a surface-mount package to be operated at industrial temperature
Pin Description:
VCC: Supply pin
D0-D7: Data input pin
GND: Reference potential pin
W-CLK: Word Load Clock pin
FQ-UD: Frequency Update pin
Data: Serial data input through D7 pin
Reset: Master reset pin
Sine-Wave 1: DAC Current Output pin
Sine-Wave 2: DAC Current Output pin
Square-Wave 1: DAC Complementary Output pin
Square-Wave 2: DAC Complementary Output pin
Input/Output pins: These are 8-bit data pins used to load data up to 32-bit frequency and 8-bit phase/control word. D7(MSB) also serves the purpose of loading a 40-bit serial data word.
W-CLK: A Word Load Clock is used to synchronize and load words serially or through parallel transmission.
FQ-UD: Frequency Update is used to update the frequency in the input data register when the clock has a rising edge. After updating, it reset the pointer to the word 0
DATA: This pin is connected to the D7 input pin. It is used to load serial data.
RESET: A master RESET is used to clear all the registers except for the IC’s input register by putting it into a HIGH state. Moreover, the outputs of DAC will be converted to Cosine 0 after some clocks.
Useful Link:
AD9850 DDS Signal Generator Module Datasheet
Package Included:
1 x AD9850 DDS Signal Generator Module DDS Function Generator Module AD9850 Direct Digital Synthesizer Module For Electronics Projects
DAC with Spurious Free Dynamic Range to specify the generator’s performance
It contains a power-down function for a short boot time.
Data transmission can either be parallel or serial.
Power Dissipation depends on the power supply voltage.
Four Analog signal outputs i.e., Sine-Wave 1, Sine-Wave 2, Square-Wave 1, and Square-Wave 2
A comparator to generate less jittering in square wave output
Direct Digital Synthesizer is based on CMOS Technology for better functionality and performance.
A small high-performance module with a surface-mount package to be operated at industrial temperature