A2212/6T 2200KV Brushless Outrunner Motor for RC Projects - RS029

SKU RS029

RS029 is an A2212-series three-phase brushless motor for RC aircraft and suitable experimental propulsion projects. The product photo identifies this version as A2212/6T 2200KV.

₹658.50

18% GST added at checkout

In stock

₹150 flat shipping, free over ₹3000

  • Pay by UPI: GPay, PhonePe, Paytm & BHIM (no gateway fees)
  • GST invoice on every order
  • Payment confirmed by us before dispatch (no auto-charge)
  • Dispatched in 2–4 working days from Agra, Uttar Pradesh.

Buying for a school or in bulk? Ask us for institutional pricing. Get a quote

About this product

A2212/6T 2200KV brushless outrunner motor RS029 is an A2212-series three-phase brushless motor for RC aircraft and suitable experimental propulsion projects. The product photo identifies this version as A2212/6T 2200KV. Its outer bell rotates around the fixed motor base, so the installation needs clearance around the rotating case as well as the shaft. Choose the correct KV version The 2200KV rating describes approximate no-load revolutions per minute for each applied volt. It is not a wattage rating, a guaranteed loaded speed or a promise of thrust. Do not substitute this motor for a lower-KV A2212 version without checking the battery, propeller, ESC and airframe together.

Model shown: A2212/6T.

KV rating: 2200 RPM/V, approximately, without load.

Motor type: three-phase brushless outrunner.

Existing listing battery range: 2S to 3S LiPo, subject to a compatible complete setup.

Listed shaft diameter: approximately 3.17mm; measure the supplied shaft before choosing a replacement adapter.

Requires a brushless ESC Connect the three motor leads to the motor outputs of a compatible brushless electronic speed controller. This is not a two-wire brushed DC motor and must not be connected directly across a battery. The ESC, battery and throttle/control source are separate items. Match connector sizes and follow the ESC instructions for setup and rotation direction. Propeller and mounting checks Use a propeller and adapter suited to the verified motor, battery and application. Keep the battery disconnected while fitting hardware. Check that mounting screws cannot reach the windings, secure the motor firmly and keep the rotating bell clear of wires. Remove the propeller for initial ESC setup and direction checks. Loaded current changes with propeller load and voltage. Measure it with suitable test equipment rather than relying on a generic A2212 thrust chart. Stop if the motor or ESC overheats or vibrates. No universal thrust, payload, maximum-power or waterproof rating is claimed. Package Includes one A2212 2200KV motor and propeller adapter. The product photo also shows mounting hardware; confirm the supplied hardware before planning the installation. Propeller, ESC, battery and aircraft are not included. SKU: RS029.

More in Drone Motors & Frames

You might also need