About this product
Compact 5V cooling fan for electronics projects
RS5651 is a small DC cooling fan in the 3010 size class: a nominal 30mm x 30mm frame with 10mm depth. It is intended for local airflow in a compatible electronics enclosure, development-board case or other low-voltage project. The photographed fan has a black plastic frame, four corner mounting holes and red and black leads ending in a white two-pin connector.
Check the fan and the mounting space
Working supply: 5V DC.
Nominal frame size: 30mm x 30mm x 10mm.
Connection: two power leads with a white two-pin plug.
Frame and blades: black plastic.
Package quantity: one cooling fan.
Check the actual mounting-hole pattern, screw clearance, cable routing and connector match before ordering or fitting. A 30mm fan does not fit every Raspberry Pi case. The connector is not a direct replacement for two separate female jumper connectors; an appropriate adapter may be needed.
Power and control
Use a suitable regulated 5V supply with enough current capacity for startup and operation. Verify the supplied fan's label and connector polarity before applying power. Red and black conventionally identify positive and ground, but confirm the wiring rather than assuming a socket's pin order. Do not connect this 5V fan to a 12V or 24V printer fan output.
The two-wire arrangement does not provide a separate speed-sense or four-wire PWM control lead. For software-controlled switching, use an appropriate transistor or MOSFET driver circuit and compatible power arrangement. Do not use a microcontroller GPIO output as the fan's power source. A Raspberry Pi's 5V power pins are not the same as its programmable GPIO signal pins.
Airflow and installation
Check the actual airflow direction before mounting and leave an open inlet and outlet path. Position it to move air through the enclosure or across the part that needs cooling. Do not block the blades against a case wall. Keep fingers, loose wires and debris clear; fit suitable guards where needed.
Cooling results depend on enclosure ventilation, placement, ambient temperature and heat output. No particular temperature drop, noise level, RPM, bearing type or service life is claimed here. Clean accumulated dust with power disconnected and replace a damaged or unreliable fan.
Includes one 5V 3010 cooling fan with attached leads and connector. Controller, case, power supply, connector adapter and mounting hardware are not included. SKU: RS5651.