About this product
Description:
The TX-ASK is an effective low-cost solution for using the 433 MHz frequency. This ASK hybrid transmitter module is designed with a saw resonator, making it small, cost-effective, and easy to use for designing. However, it's important to note that this 433mhz rf transmitter and receiver kit does not support direct UART communication when connected to PCs or microcontrollers due to the high levels of noise on these frequencies.
The RF module comprises a 433mhz rf transmitter and receiver. The transmitter receives serial data and wirelessly transmits it through RF via its antenna connected at pin4. The transmission rate can be set to 1kbps or 10kbps. The transmitted data is received by an RF receiver operating at the same frequency as the transmitter. This 433 MHz RF transmitter and receiver pair is cost-effective and can transmit signals up to 100 meters (although the antenna design, working environment, and supply voltage will significantly impact the effective distance). It's ideal for short-distance battery-powered device development.
Specifications:
Receiver:
Operating Voltage: DC5V
Quiescent Current: 4MA
Receiving Frequency: 433.92MHZ
Receiver Sensitivity: -105DB
Launch Distance: 20-200 meters (different voltage, different results)
Transmitter:
Operating Voltage: 3.5-12V
Operating Mode: AM
Transfer Rate: 4KB / S
Transmitting Power: 10mW
Transmitting Frequency: 433M
Pin Description:
Receiver:
No.
Pin Name
Description
1
VCC
Power supply (3V to 12V)
2
DATA
Data received can be obtained from this pin
3
DATA
It serves the same purpose (anyone can be used)
4
GND
Connected to the ground of the circuit
5
ANTENNA
Solder wire/antenna to improve range (not mandatory
Transmitter:
No.
Pin Name
Description
1
VCC
Power supply (+5V only)
2
DATA
Data to be transmitted is sent to this pin
3
GND
Connected to the ground of the circuit
4
ANTENNA
Solder wire/antenna to improve range (not mandatory)
Package Included:
1 x 433Mhz RF Transmitter With Receiver