About this product
Open four-AA battery holder for portable electronics
RS060 is a black plastic holder for four AA cells, with red and black wire leads for connection to a suitable low-voltage project. The flat, open design gives access to each battery slot. It is useful for classroom circuits, portable prototypes and replacement battery-compartment projects where the cell format, output voltage and physical fit have been checked.
What this holder provides
Capacity: 4 x AA cells.
Open-top plastic body without a cover.
Spring contacts and moulded polarity marks.
Red and black output leads.
Batteries are not included.
Understand the pack voltage
A four-cell series pack gives a nominal 6V with four 1.5V alkaline AA cells, or a nominal 4.8V with four 1.2V NiMH rechargeable AA cells. The output is not regulated: the actual voltage changes with chemistry, state of charge and load. Check the receiving circuit's permitted input range and confirm the assembled pack voltage before connection.
This is not a regulated 5V supply, charger or protection board. Do not connect the leads directly to a controller GPIO. Use an appropriate power-input circuit, regulator, switch and protection where the project requires them. No current rating or universal motor compatibility is claimed for this holder.
Fit cells and connect carefully
Disconnect the project while inserting batteries. Follow the moulded plus and minus marks in every slot, rather than assuming all cells face the same direction. Red is normally positive and black negative; verify output polarity with a meter before connecting a sensitive circuit. Insulate wire joins and prevent the two output leads from touching.
Use a matched set of cells. Do not mix old and new batteries, brands or chemistries. Never try to recharge non-rechargeable cells. Rechargeable cells need a charger intended for their chemistry; the holder itself does not manage charging.
Mounting and package contents
Secure the holder in a suitable dry project enclosure, away from heat, loose metal and moving parts. Remove batteries for extended storage. Includes 1 x black four-AA battery holder with leads and no cover. Cells, connector, switch, regulator and project circuit are not included. SKU: RS060.