About this product
This is the combination of MEGA2560 + RAMPS1.4 + 5 x A4982 drivers (remix board)
Using ATMEGA2560-16AU, and improve its performance highly.
Support network function, then proceed remote control via IE Explorer.
Up to 5 motor drivers with A4982
Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board
Description :
This is the combination of MEGA2560 + RAMPS1.4 + 5 x A4982 drivers (remix board)
Firmware can use the same configuration as RAMPS1.4
It is suitable for dual-Extrude printer
Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board
3x temperature ADC connectors for thermistors
Up to 5 motor drivers with A4982
4x PWM capable power MOSFET outputs with voltage selector for MainPower.(Bed, Extruder0, Extruder1, Fans)
4 layers PCB, optimize heat dissipation.
6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
Recoverable fuse for short-circuit protection.
USB Driver Chip FT232RL, you can get files from ftdi chip to setup driver: Ftdi-x86.zip
Using professional power chip, support 12V-24V DC input.
Good to work with 12864LCD and MKS TFT touch screen.
Using A4982 stepper driver which supports 32-microstep and with excellent cooling.
Currents of the stepper motor can be set directly, which can avoid the damage.
Support highly modular open source firmware Smoothieware, easy for secondary development.
Package Included :
1 x 3D Printer Control Board MKS BASE V1.6 Board RepRap Ramps1.4 Compatible Development Board