About this product
3-pin, 2-position SPDT slide switch
RS4980 is a small manually operated slide switch with three solder terminals, a black plastic slider and a metal body with a mounting hole at each end. It provides single-pole, double-throw switching: one common contact is connected to one of two other contacts, depending on the selected position. Use it for low-power circuit selection, a mode input or a simple on/off function in a suitable electronics project.
What SPDT means
One pole means one circuit is switched. Two throws means that circuit can select between two paths. This is not a double-pole switch and does not switch two independent circuits together. It is also not a complete motor-reversing switch. A motor reversal arrangement normally needs a suitable reversing circuit or motor driver.
Contact arrangement: SPDT.
Terminals: three solder contacts.
Positions: two.
Construction: metal body and plastic actuator.
Mounting: two end holes, visible in the product photos.
Listed contact limits: 50V and 0.5A. Check suitability for the actual circuit and load.
Check the contacts before connecting
With all power disconnected, use a continuity meter to identify the common terminal and the connected pair in each position. Do not infer the active contact from slider direction alone. Physical terminal order and the logical diagram should be checked against the actual switch before soldering. The guide images explain the switching function rather than specifying a numbered pinout.
Wiring and installation
For one-of-two selection, connect the common and both throws to the intended low-power circuit. For on/off operation, use the common and one throw, leaving the unused terminal insulated. Prevent solder bridges and exposed conductors from touching the metal body or neighbouring terminals. Never use the switch to join two incompatible power sources.
Check the body dimensions, mounting-hole spacing, terminal spacing and slider clearance against your enclosure or board before assembly. Support the body mechanically so repeated operation does not strain solder joints. Exact dimensions and contact resistance are not specified here because the supplied listing does not provide a verified drawing or test value.
Application limits and package
Use in low-voltage, low-power electronics only, not mains wiring. Motors, lamps and capacitive loads can draw high starting current, so use a suitably rated driver where needed. The stated limits do not establish suitability for every load. Includes one RS4980 SPDT slide switch. Wires, circuit board, enclosure and tools are not included.