About this product
Operating Voltage: 3.3V/5V DC
Display Size: 2.9 inch
Outline Dimension: 89.5mm × 38mm
Dot Pitch: 0.138 × 0.138
Description:
2.9-inch e-Ink Paper Display Module with SPI Interface is an E-Ink display module, 2.9inch, 296×128 resolution, with an embedded controller, communicating via SPI interface, supports partial refresh. Due to the advantages like ultra-low power consumption, wide viewing angle, great effect under sunlight, it is an ideal choice for applications such as shelf label, industrial instrument, and so on. There is no backlight so it can keep displaying last content for a long time even when the power is down. As these displays have no backlight panels and it doesn’t need a continuous power supply to display the (static data with periodic intervals) data on the screen, it has a great advantage of ultra-low power consumption. Also, it has a wide viewing angle, great viewing effect under sunlight, Basically power to the display is only required for refreshing. For connecting with controller boards like Raspberry Pi/Arduino/Nucleo, etc. SPI interface can be used.
Specification:
Operating Voltage
3.3V/5V DC
Display Size
2.9 inch
Outline Dimension
89.5mm × 38mm
Dot Pitch
0.138 × 0.138
Grey level
2
Display Color
Black and White
Display Resolution
296×128
Viewing Angle
>170°
Interface
3-wire SPI, 4-wire SPI
Partial Refresh Time
0.3s
Full Refresh Time
2s
Refresh Power
26.4mW(typ.)
Standby Power
<0.017mW
Features:
No backlight keeps displaying last content for a long time even when a power down
Ultra low power consumption, basically power is only required for refreshing
SPI interface, for connecting with controller boards like Raspberry Pi/Arduino/Nucleo, etc.
On-board voltage translator, compatible with 3.3V/5V MCUs
Interface:
VCC:3.3V/5V
GND:Ground
DIN:SPI MOSI pin
CLK:SPI SCK pin
CS:SPI chip selection, low active
DC:Data/Command selection (high for data, low for command)
RST:External reset, low active
BUSY:Busy status output, high active
Package Included:
1 x 2.9-inch e-Ink Paper Display Module with SPI Interface
1 x Interfacing Cable
No backlight keeps displaying last content for a long time even when a power down
Ultra low power consumption, basically power is only required for refreshing
SPI interface, for connecting with controller boards like Raspberry Pi/Arduino/Nucleo, etc.
On-board voltage translator, compatible with 3.3V/5V MCUs