About this product
24MHz 8-channel USB logic analyzer
AA161 captures digital high/low transitions so you can inspect communication timing and decode supported protocols on a computer. Use it for low-voltage embedded projects, checking an I2C acknowledgement, following UART traffic or comparing SPI clock and data signals. This is a digital logic analyzer, not an analog oscilloscope, multimeter or standalone display.
Hardware overview
Eight digital input channels.
Listed maximum sampling rate: 24 million samples per second, not 24MHz guaranteed signal bandwidth.
USB-powered unit in a compact black enclosure with a mini-USB connector.
Header channel and GND markings shown on the case label.
The photo shows a CLK label as well as channel labels. Do not assume an external-clock mode is supported by your software. Verify header orientation on the supplied unit and confirm how physical channel numbers map to the software's channel names before decoding.
Software and protocol decoding
Use open-source sigrok/PulseView with the appropriate driver and firmware for the detected hardware. Similar FX2-based analyzers use the fx2lafw driver; confirm device detection rather than assuming a particular internal chip revision. Windows may need a compatible USB driver. Driver setup and supported operating systems depend on the installed software release.
UART, I2C and SPI decoding is performed by software after capture. Decoder availability does not make the inputs suitable for every electrical interface. Never connect CAN-H/CAN-L, RS-232, RS-485, mains, motor power or negative-voltage signals directly. A suitable physical-layer receiver or level interface is needed where applicable. Saleae Logic software is not included or promised compatible; follow the software vendor's hardware and licence terms.
Connection and first capture
Power down the circuit before attaching leads. Check that its voltage levels and ground reference are safe for the analyzer and USB-connected computer.
Connect the marked GND to the circuit's logic ground, then connect the required channel inputs. Do not infer pin function from jumper colour.
In PulseView, select the detected device, enable the required channels and start with a slow, known digital signal.
Choose a sampling rate comfortably above the fastest signal of interest. Set capture duration and decoder channel assignments, then compare the result with the expected timing.
Exact input protection and voltage thresholds depend on the board revision and are not verified from the external photos. Confirm them before use; add suitable level protection when needed. USB power does not mean the unit supplies power to the test circuit. It is not an isolated instrument.
Package
1 x USB logic analyzer, 1 x USB cable and 1 x 10-wire female-to-female jumper set. Test circuit and computer are not included.