About this product
17HS3401 NEMA 17 Stepper Motor with Cable
Build a controlled-motion project with this compact 17HS3401 bipolar stepper motor. The motor shown has a square NEMA 17 frame, a projecting shaft and a detachable four-wire connection cable. It is intended to work with a suitable stepper motor driver and a controller, rather than being connected directly to a battery or a microcontroller output.
What this motor is for
A stepper motor divides rotation into commanded steps. It can be used in small positioning mechanisms, robotics experiments and custom motion assemblies. In a 3D printer or CNC conversion, check the mechanical fit, shaft coupling, driver capability and load requirements before choosing it as a replacement. NEMA 17 describes the frame size; it does not guarantee a particular torque, speed or compatibility with every machine.
Connection and driver selection
The four motor leads form two coil pairs. With all power disconnected, identify the pairs using the motor documentation or a continuity/resistance check. Connect each complete pair to the corresponding output pair on a compatible bipolar stepper driver. Do not assume wire colours or connector pin order match a different motor.
Use a current-limited driver and set its current limit to suit the actual motor rating. The driver supply voltage is not the same as the motor winding voltage. Check the driver manual for power wiring, decoupling and cooling requirements. Do not connect or disconnect the motor while the driver is powered, because this can damage the driver.
First-start checklist
Secure the motor and keep the shaft clear.
Start unloaded with slow step pulses.
Increase speed and acceleration gradually.
Check temperature and watch for missed steps under load.
Exact winding current, resistance and torque should be confirmed from the supplied motor's specification before final driver setup. Do not use a generic NEMA 17 rating as a substitute.
Package contents
1 x 17HS3401 NEMA 17 stepper motor with four-wire cable. Driver, controller, power supply, mounting hardware and shaft coupling are not included. SKU: RS6097.