About this product
USB Low/Full-Speed Isolator Board
This inline USB isolation board sits between a computer's USB Type-A port and a compatible USB peripheral. It has a male USB Type-A plug on the host side, a female Type-A socket for the device and two onboard switches for speed configuration.
The ADuM4160/ADuM3160 isolator family supports USB low-speed and full-speed signalling at 1.5Mbps and 12Mbps. It does not provide USB high-speed 480Mbps operation. Check that your peripheral can operate at one of the supported speeds before using this board; a USB 2.0 label alone does not establish compatibility.
Key details
Form: inline USB isolation development board
Host connection: USB Type-A male
Peripheral connection: USB Type-A female
Supported signalling family: low speed and full speed
Data rates: 1.5Mbps / 12Mbps, subject to correct switch configuration
Onboard speed-selection switches
Compatibility and setup
Disconnect the board before changing switch settings. Use the board markings and the peripheral's documented USB speed to choose the setting. Both sides of the isolation circuit must be configured for the same speed. Keep power requirements in mind: do not assume the module can supply the current demanded by external drives or other power-hungry peripherals.
Important safety note
This is an exposed development board, not a finished safety-certified enclosure. A component's isolation test voltage is not a guarantee that an assembled system is safe for mains-connected or medical use. Do not use it as the only protection against electric shock. High-voltage applications require a qualified design review and suitable system-level protection.
Package contents
1 x USB-to-USB isolator board. USB peripherals and cables are not included.