About this product
12V DC normally closed plastic water solenoid valve
RS3065 is a normally closed water solenoid valve listed for 12V DC operation with nominal 1/2-inch threaded ports. The product photos show a white plastic inline body, a metal coil bracket and two electrical spade terminals. It is intended for controller-operated water-flow experiments and automation projects where the actual valve specifications meet the installation requirements.
Product details
Valve function: normally closed, NC.
Listed coil supply: 12V DC.
Listed connection size: nominal 1/2 inch.
Photographed body: white plastic with an external solenoid coil.
Electrical connection: two spade terminals.
Package: 1 x solenoid valve, SKU RS3065.
Normally closed means the valve is intended to close without coil power and open when correctly energised under its required water conditions. It does not establish a leak-proof or safety-certified shutoff. Keep a suitable manual water shutoff available.
Confirm plumbing compatibility
Check the actual inlet, outlet and any flow-direction arrow before installation. Match the thread standard and seals to the supplied part; a nominal 1/2-inch fitting is not interchangeable with a 20mm metric thread simply because the diameters look similar. Avoid over-tightening or loading the plastic body with unsupported pipework.
Similar-looking valves have different minimum pressure requirements. Do not assume this valve will work from a gravity-fed tank or at zero pressure. Confirm the supplied valve's pressure, water-temperature and flow limits before choosing it. These exact limits and the permitted coil duty cycle are not established by this listing.
Electrical control and first test
Use a suitable external 12V DC supply and switching driver rated for the actual coil current. Do not connect the coil directly to an Arduino or other controller GPIO. Use appropriate DC flyback suppression and check any built-in diode and polarity requirements. Non-isolated switching circuits need the correct common reference.
Isolate electrical power and release water pressure before wiring or servicing. Keep electrical terminals dry and insulated. Start with a supervised water test, checking for leaks, correct opening and shutoff, and excessive coil heating. Confirm allowed energised time before unattended operation.
No suitability is established for compressed air, gas, fuel, chemicals, drinking water or safety-critical isolation. Pipe fittings, driver, protection components, controller and power supply are not included.