About this product
12864 Full Graphic LCD Smart Controller for Compatible 3D Printers
The RS1059 is a RepRapDiscount-style full graphic controller set with a 128 x 64 monochrome LCD, rotary encoder with push action, buzzer, stop button and SD-card slot. It provides a local control panel for a compatible 3D-printer mainboard running correctly configured firmware.
The supplied RAMPS-style adapter and ribbon cables are intended for compatible RAMPS 1.4 / Mega 2560 installations. Other boards need a matching pinout and firmware configuration. A similar connector or a claim of "12864 support" alone does not prove compatibility.
Features and interfaces
128 x 64 pixel graphic LCD, not a 20 x 4 character display.
Rotary encoder for navigating menus and a push action for selection.
SD-card reader for supported firmware-based printing workflows.
Two rear 10-pin IDC headers labelled EXP1 and EXP2.
RAMPS-style adapter board and ribbon cables shown in the set photos.
The panel is not a standalone printer controller and does not directly power heaters or motors. Menus, languages, temperature controls, SD-card behaviour and the stop-button response are determined by the mainboard and firmware. Do not use a software stop button as a substitute for a suitable hardware emergency-power arrangement.
Firmware setup
In Marlin, the full-size graphic controller family normally uses REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER in Configuration.h. This is different from REPRAP_DISCOUNT_SMART_CONTROLLER, which is for the 20 x 4 character family. Select the option appropriate to the actual panel and mainboard, then build and install firmware using the board's instructions.
Clone panels can differ in LCD driver, connector orientation and timing requirements. Confirm the exact board revision before changing firmware settings. This listing does not promise a specific driver IC, universal firmware compatibility or a preconfigured menu.
Connection checks before applying power
Disconnect the printer's power and USB connection before fitting or removing the panel, adapter or cables.
Match EXP1 to the intended EXP1 connection and EXP2 to EXP2, using the mainboard documentation. Verify pin 1, power, ground and signal mapping at both ends.
Check for reversed or offset connectors. Do not force keyed plugs, cut keys or rotate headers by trial and error.
Ensure the adapter is seated on the correct RAMPS headers without shifted pins. Keep ribbon cables away from heater, motor and mains wiring.
If the display is blank, flickers or shows corrupt graphics, power down and verify wiring and firmware before attempting adjustments. Check contrast only after the connections are correct.
Package includes
1 x 12864 full graphic controller panel, 1 x RAMPS-style adapter and the ribbon cables shown. Printer mainboard, SD card, enclosure and power supply are not included. Confirm the supplied cable length if it is important to your enclosure design.